REFACE POLYESTER SPRAYABLE FILLER 1L Kit
£29.99 + VAT
- Brand: U-POL
- Product Code: Reface
- Availability: In Stock
A highly effective two component sprayable polyester filler specially developed to spray large areas of repair. Ideal base for most paint systems.
- High film build
- Easy sand
- Liquid hardener included
Description
U-POL REFACE is a highly effective, two component sprayable polyester for the preparation
of steel and fiberglass surfaces. U-POL REFACE gives a very high build, adheres excellently
to metal and is easy to sand creating an ideal base for most paint systems.
Surface preparation and
instructions for use
U-POL REFACE can be applied to the following -
• Bare metal. (*)
• Polyester putties and bodyfillers.
• Fiberglass and SMC.
• Fully cured paint surfaces.
* Note: REFACE is not recommended for use over Aluminum, Galvanized (Zinc coated) or
etch primers.
Thoroughly clean and degrease surface with a suitable degreaser. Sand with 80 grit paper
for bare metal or 220 grit for painted surfaces. Re-clean and dry.
Hardener
Add U-POL REFACE hardener at 5 parts per 100 by volume or 3% by weight. Mix
thoroughly. Only mix amount required for immediate work. Never return unused mixed
product to the can.
Application
Stir well before use. Minimum recommended working temperature is 50ºF. Application with a
gravity fed gun is preferable, though a suction gun will suffice. Use a 2mm-3mm fluid tip.
Hold gun 6-8 ins from panel. Layers may be built up wet on wet, but 5-10 minutes between
coats is recommended.
Pot life 45-60 minutes at 70ºF Reducers Reducing is not recommended.
Use lacquer thinners or similar proprietary products to clean gun. Build and pressure 2-3 spray cycles of several layers will give a very high build.
At a pressure of 40-50 PSI, each pass will give a build of approximately 5-7 MIL.
Drying time 2-3 hours at 70ºF or 30 mins at 140ºF. Drying time is dependent upon film thickness, humidity and temperature.
Over-painting Dry sand, clean and dry thoroughly, U-POL REFACE may then be overcoated with most
primers and paint systems. A non sanding sealer is necessary if used in damp climatic
conditions.